SDI Connections - NVIDIA Quadro K4000-K6000 SDI Cards

This section provides illustrations and instructions for connecting to the SDI and external sync connectors on NVIDIA Quadro K4000/K5000/K6000 SDI cards.

Instructions for connecting the display connections

• NVIDIA Quadro K5000/K6000 SDI

• NVIDIA Quadro K4000 SDI

Instructions for connecting the House Sync and SDI Output connections

• House Sync and SDI Output Connections

NVIDIA Quadro K5000/K6000 SDI

DVI-to-DVI Connection

Connect one end of the DVI cable to the DVI connector on the SDI Output card and the other end to the DVI connector on the NVIDIA Quadro SDI card as shown. The SDI output will not work if the cable is not connected to these two connectors.

Display Output Connection

Connect your display to one of the available digital connectors indicated:

NVIDIA Quadro K4000 SDI

DVI-to-DVI Connection

Connect one end of the DVI cable to the DVI connector on the SDI Output card and the other end to the DVI connector on the NVIDIA Quadro SDI card as shown. The SDI output will not work if the cable is not connected to these two connectors.

Display Output Connection

Connect your display to the one of the available digital connectors indicated:

House Sync and SDI Output Connections

The BNC connector locations for the house sync input and SDI output are shown in the figure below, with corresponding descriptions in the following table. The order of the connector descriptions in the table follows the same left-to-right order of the connectors in the figure.

Related topics

• Set up my SDI output

• Adjust the desktop area to send to the SDI output

• Specify gamma correction for the SDI output

• Set up colour space conversion

• View the status of my SDI setup

• Synchronising the SDI Output

• Introducing a delay in the SDI output

• View SDI Status

• Recommended Operating Practices