Add a Point Parameter

Up a level to ..

Add a Polar Parameter

 

Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Actions and Parameters to Dynamic Blocks > Add Action Parameters to Dynamic Blocks > 

Add a Linear Parameter

Expand All Expand all collapsed sections. Collapse All Collapse all expanded sections.

Concept

Procedure

Quick Reference

To add a linear parameter to a dynamic block definition

1. Click Insert tab Block panel Block Editor. At the Command prompt, enter bedit.
2. Click Block Editor tab Dimensional panel Linear. In the Block Editor, in the Block Authoring Palettes window, Parameters tab, click the Linear Parameter tool.
3. (Optional) Follow the Command prompts to specify the following for the parameter:
   • Type
   • Label
   • Description
   • Value set
   • Chained Actions
   • Properties displayed for block reference
   NoteYou can also specify and edit these properties in the Properties palette at a later time, after you've added the parameter to the block definition.
4. Specify a base point for the parameter.
5. Specify an endpoint for the parameter.
6. Specify a location for the parameter label
7. Follow the prompts to associate an action with the parameter and a selection set of geometry.
8. Click Block Editor tab Open/Save panel Save Block. At the Command prompt, enter bsave.
9. If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Standard 

 Command entry: BPARAMETER