Add an XY Parameter

Up a level to ..

Add a Flip Parameter

 

Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Actions and Parameters to Dynamic Blocks > Add Action Parameters to Dynamic Blocks > 

Add a Rotation Parameter

Expand All Expand all collapsed sections. Collapse All Collapse all expanded sections.

Concept

Procedure

Quick Reference

To add a rotation parameter to a dynamic block definition

1. Click Insert tab Block panel Block Editor. At the Command prompt, enter bedit.
2. Click Block Editor tab Action Parameters panel Rotation.In the Block Editor, in the Block Authoring Palettes window, Parameters tab, click the Rotation Parameter tool.
3. Follow the Command prompts to specify the parameter type.
4. Specify a base point for the parameter.
5. Specify the radius for the parameter.
6. Specify a base angle for the parameter.

   The angle shown in the Properties palette when you select the block reference in a drawing is measured relative to the base angle specified in the block definition.

7. Specify a default rotation angle for the parameter.
8. Specify a location for the parameter label.
9. To add an action now, double-click the alert icon. Follow the prompts to associate an action with the parameter and a selection set of geometry.
10. Click Block Editor tab Open/Save panel Save Block. At the Command prompt, enter bsave.
11. If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Standard 

 Command entry: BPARAMETER