Specify Value Sets for Dynamic Blocks

Up a level to ..

Specify Value Sets for Dynamic Blocks

 

Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Specify Custom Properties for Dynamic Blocks > 

Specify Value Sets for Dynamic Blocks

Expand All Expand all collapsed sections. Collapse All Collapse all expanded sections.

Concept

Procedure

Quick Reference

To specify an incremental value set for a linear, polar, XY, or rotation parameter

1. Ensure that the Properties palette is displayed. If not, click Tools menuPalettesProperties.At the Command prompt, enter properties.
2. Click Insert tab Block panel Block Editor. At the Command prompt, enter bedit.
3. In the Block Editor, select a linear, polar, XY, or rotation parameter.
4. In the Properties palette, under Value Set, click Dist Type, Ang Type, Hor Type, or Ver Type.
5. On the drop-down list, select Increment.
6. In the Properties palette, under Value Set, click Dist Increment, Ang Increment, Hor Increment, or Ver Increment, and then enter an incremental value for the parameter.
7. Click Dist Minimum, Ang Minimum, Hor Minimum, or Ver Minimum, and then enter a minimum value for the parameter.
8. Click Dist Maximum, Ang Maximum, Hor Maximum, or Ver Maximum, and then enter a maximum value for the parameter.
9. Click Block Editor tab Open/Save panel Save Block. At the Command prompt, enter bsave.
10. (Optional) If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Standard 

 Command entry: PROPERTIES