Click Insert
tab Block
panel Block
Editor. At the Command prompt, enter bedit.
In the Block Editor, in the Block Authoring
Palettes window, Actions tab, click the Array Action tool.
In the Block Editor drawing area, select
a parameter to associate with the action. (You can associate linear,
polar, and XY parameters with an array action.)
Select the objects (the selection set)
to associate with the action. Press Enter.
If you are associating the array action
with an XY parameter, do one of the following:
Enter the distance between rows.
Specify a unit cell by entering two values
separated by a comma or by picking two opposite points of a rectangle
in the drawing area, and then go to step 7.
Enter a value for the distance between
columns.
If you are assigning the array action
to an XY parameter, enter the distance between rows.
Specify the location of the action.
Click Block
Editor tab Open/Save
panel Save
Block. At the Command prompt,
enter bsave.
If you are finished using the Block Editor,
click Close Block Editor.