Enter 3D Cartesian Coordinates
Expand All
Expand all collapsed sections.
Collapse All
Collapse all expanded sections.
ConceptProcedureQuick Reference
 
 
 

3D Cartesian coordinates specify a precise location by using three coordinate values: X, Y, and Z.

Entering 3D Cartesian coordinate values (X,Y,Z) is similar to entering 2D coordinate values (X,Y). In addition to specifying X and Y values, you also specify a Z value using the following format:

X,Y,Z

NoteFor the following examples, it is assumed that dynamic input is turned off or that the coordinates are entered on the command line. With dynamic input, you specify absolute coordinates with the # prefix.

In the illustration below, the coordinate values of 3,2,5 indicates a point 3 units along the positive X axis, 2 units along the positive Y axis, and 5 units along the positive Z axis.

Use Default Z Values

When you enter coordinates in the format X,Y, the Z value is copied from the last point you entered. As a result, you can enter one location in the X,Y,Z format and then enter subsequent locations using the X,Y format with the Z value remaining constant. For example, if you enter the following coordinates for a line

From point: 0,0,5

To point: 3,4

both endpoints of the line will have a Z value of 5. When you begin or open any drawing, the initial default value of Z is greater than 0.

Use Absolute and Relative Coordinates

As with 2D coordinates, you can enter absolute coordinate values, which are based on the origin, or you can enter relative coordinate values, which are based on the last point entered. To enter relative coordinates, use the @ sign as a prefix. For example, use @1,0,0 to enter a point one unit in the positive X direction from the previous point. To enter absolute coordinates at the command prompt, no prefix is necessary.

Digitize Coordinates

When you enter coordinates by digitizing, the UCS Z value for all coordinates is 0. You can use ELEV to set a default height above or below the Z = 0 plane for digitizing without moving the UCS.