ALM-4762 DSP Version Report Alarm

Description

This alarm is generated only when TRXs are in the aging state. When the DSP version is queried, there is no response.

Attribute

Alarm ID Alarm Severity Alarm Type
4762 Warning Fault

Parameters

ID Name Meaning
1 Site No.

Number of the site where the faulty board or module is located

Value range: 0-2047

2 Board Type

Number of the type which the faulty board belongs to.

64:DTMU/DOMU

87:GTMU

3 Board No.

Number of the fault board

0-5:DTMU/GTMU

4 PassNo

Number of the passage where the faulty board is located.

5 SubLink No.

Alarm sub-category number

Sub No. 0:no response to queries about DSP version of TRX of cell 0

Sub No. 1:no response to queries about DSP version of TRX of cell 1

Sub No. 2:no response to queries about DSP version of TRX of cell 2

Sub No. 3:no response to queries about DSP version of TRX of cell 3

Sub No. 4:no response to queries about DSP version of TRX of cell 4

Sub No. 5:no response to queries about DSP version of TRX of cell 5

6 Cell Index

Index of the cell where the board or module is located

0-2047: Cell index of the faulty cell in the data configuration

65535: None

7 Site Type

Type of the site where the faulty board is located.

12:BTS3012;

13:BTS3006C;

14:BTS3002E;

15:BTS3012AE;

16:BTS3012 II;

17:DBS3900 GSM;

18:BTS3900 GSM;

19:BTS3900A GSM;

8 RackNo

Number of the rack where the faulty board is located.

9 BoxNo

Number of the subrack where the faulty board is located.

10 SlotNo

Number of the slot where the faulty board is located.

11 Site Name

Site Name

12 Alarm Attribute

Alarm Character

0:Normal

1:Transient Count

Impact on the System

When the alarm is generated, TRXs of the cell related to the alarm cannot enter the aging state.

System Actions

None.

Possible Causes

The TRX software of the cell related to the alarm is faulty.

Procedure

  1. Reset the TRXs of the cell related to the alarm.

    Observe whether the alarm is cleared after the resetting.

    Y=> The alarm is cleared. Alarm handling is complete.

    N=> The alarm is not cleared. Go to step 2.

  2. Replace the TRXs of the cell related to the alarm

    Observe whether the alarm is cleared after the replacement.

    Y=> The alarm is cleared. Alarm handling is complete.

    N=> The alarm is not cleared. Please contact Huawei Customer Service Center.


Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.