Configuring the M3UA Route

This describes how to configure the M3UA route for implementing the IP transmission between the BSC and the MSC.

Scenario	BSC initial configuration and BSC capacity expansion
Mandatory/Optional	Mandatory

The DSP for the M3UA entity is configured. For details, see Configuring the M3UA Entities.
The M3UA link set is configured.

Preparation

**Table 1** Example of the data negotiated and planned for configuring the M3UA route
Parameter	Example	Source
Destination Entity Name	MSC001	Negotiation with the peer
LinkSet Name	0	BSC internal planning

On the BSC6000 Local Maintenance Terminal, right-click the BSC6000 root node.
Choose Configure M3UA Data > Configure M3UA Entity from the shortcut menu. A dialog box is displayed, as shown in Figure 1.
Figure 1 Configure M3UA Route dialog box
Click Add. A dialog box is displayed, as shown in Figure 2.
Figure 2 Add M3UA Route dialog box
Set the parameters of the M3UA route by referring to Table 1.
Click OK to return to the dialog box, as shown in Figure 1.
Click OK. The M3UA route is configured.