Configuring the BSC Attributes

This describes how to configure BSC attributes. In the initial configuration of BSC attributes, you need to configure only the basic attributes. For other attributes, use the default settings. The BSC attributes include the Basic Data, Flow Control Data, BSC Timer, Software Parameters, User Resource Binding, SCCP, NSS and BSSGP, MSC Pool Parameters, Trigger Saving Power Function, IP Transfers, Abis Congestion Control, and Single Pass Exclude MSISDN Number.

Scenario	BSC initial configuration
Mandatory/Optional	Mandatory

Prerequisite

The BSC attributes are determined in network planning.

Preparation

**Table 1** Example of the data negotiated and planned for configuring BSC attributes with BM and TC separated
Parameter	Example	Source
BSC Name	BSC001	Network planning
Country Code	86	Network planning
City Code	021	Network planning
MCC	460	Network planning
MNC	10	Network planning
A Interface Tag	GSM_PHASE_2+	Network planning
Um Interface Tag	GSM_PHASE_2+	Network planning
Abis Interface Tag	GSM_PHASE_2+	Network planning
NTP Server	10.161.72.251	Negotiation with the M2000
BSC Subrack Combination Type	BM/TC separated	Network planning

Procedure

On the BSC6000 Local Maintenance Terminal, right-click the BSC6000 root node.
Choose Configure BSC Attributes from the shortcut menu. A dialog box is displayed, as shown in Figure 1.
Figure 1 Configure BSC Attributes dialog box
On the Basic Data tab page, set the parameters by referring to Table 1.
NOTE:
For other parameters, except the parameters listed in Table 1, you can use the default settings or change them as required.
Click Finish. The configuration of the BSC attributes is complete.