Adding the Operator Information

This describes how to add an account and set the password, description, operation authority, and operation time limit of the operator. Administrators can perform this operation.

Prerequisites

The LMT runs normally.
The communication between the LMT and the BSC is normal.

Context

The account of an operator must not be more than 32 characters, and must consist of letters, digits, and underlines. In addition, the account must begin with a letter.
The length of the password must range from 6 to 32 bytes.
The description of the operator must not be more than 110 characters and it can be neglected.
The operation authority can be customized. In a Command Group, if a parameter is in the disabled state, you have no operation authority of this parameter. In a Command Group, if a parameter is in the enabled state, you have the operation authority of this parameter.

Procedure

Run the ADD OP command on the LMT to add the operator information.