To enable multi-display cloning

  1. Make sure at least two DisplayPort monitors are connected through the same DisplayPort connector of the Quadro card, using certified cables and branching devices as needed.  

  2. From the NVIDIA Control Panel Select a Task pane, under Workstation, click View system topology.

  3. Locate the Quadro product that has the DisplayPort connection that supports multi-display cloning, then click the corresponding board [+] icon to expand the branch.

  4. Make sure that the EDID state is not set to (Forced). (See EDID Management)

  5. At the DisplayPort status property, click Multi-Display Cloning (Disabled).

  6. The Multi-Display Cloning page opens.

  7. Click to select the Clone displays using check box, then click the list arrow and select one of the options for determining which displays will be included in the Clone Group:

  8. Your selection determines not only which displays are included in the Clone Group, but it also determines the specific mode parameters listed in the dialogue box - resolution, refresh rate, pixel clock, colour format, and colour depth.

  9. You can select different values for each mode parameter, which will in turn affect which displays are included in the clone group.

  10. The available options for each parameter depend on the selection of other parameters as follows:

  11. Click OK when done.

 

 

Related topics