Add an Aligned Constraint Parameter

Add Dimensional Constraints to Dynamic Blocks

Add a Radial Constraint Parameter

 

Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Constraints to Dynamic Blocks > Add Dimensional Constraints to Dynamic Blocks > 

Add an Angular Constraint Parameter

Expand All Expand all collapsed sections. Collapse All Collapse all expanded sections.

Concept

Procedure

Quick Reference

An angular constraint controls the angle between two line or polyline segments, or the angle of an arc.

While an angular dimension represents the angle between two lines or three points, an angular constraint parameter defines and controls the angle.

In the example below, the polygon on the left has an angular constraint of 30 degrees applied to one corner of the polygon. When one point on that polygon is manipulated, the result is the polygon on the right. The constrained corner will remain at 30 degrees, while the geometry of the polygon will change to keep that angle.